Aluminium cone for locating the strut rod into the bottom of the upper mount.
One cone is used at each strut assembly on the front of all models and additionally on the rear of 1300 models. The rear of 1500 models do not require separate cones as they are already formed into the spring perch top.
Original cones can suffer from corrosion and fractures due to long term exposure to wet and road salt.
A strut pivot washer
SS088
locates underneath each cone.
Total required: four for 1300 models, two for 1500 models. Sold individually.

Also applicable to Lancia Beta Scorpion and Montecarlo S1 & S2 models as a replacement for the original one piece strut top unit when used with
pivot washer
SS088,
rubber seal
SS090,
and roller thrust bearing
SS070.