Low pressure EPDM hose designed for connecting hydraulic fluid reservoir to master cylinder. Now supplied unbraided in black with reinforced inner.
This hose is 6mm internal diameter, suitable for all clutch circuits and 6mm brake reservoir fittings used on 1300 models. Outside diameter 13mm.
Use with
FS014 hose clips.
Quantity price is
per 30cm (per foot), i.e. if you order quantity 4 you will receive one 120cm length (4 x 30cm). Supplied in continuous length.
For Right Hand Drive (e.g. UK & Australia) cars, you will require:
- 115cm for the clutch circuit (4 x 30cm lengths).
- 140cm for each brake circuit, so 280cm per car (10 x 30cm lengths).
For Left Hand Drive (e.g. USA & mainland Europe) cars, please check individual lengths required before ordering, although 14 x 30cm lengths for a full car set should be sufficient.
Always route hose carefully to avoid kinks and maximise the bend radius where possible. Work backwards from cylinders to reservoirs, then cut to fit once hoses are clipped in place with sufficient play. Don't cut new hose to length from your existing hoses as some original hoses are unnecessarily short.
For 8mm brake circuits, see reservoir hose
BR032.
Also applicable to Lancia Beta Scorpion and Montecarlo S1.
Brakes (52)
