Reservoir Hose - 8mm (per 30cm)

Low pressure EPDM hose designed for connecting hydraulic fluid reservoir to master cylinder. Now supplied unbraided in black with reinforced inner.

This hose is 7.3mm internal diameter, suitable for 8mm brake reservoir fittings. Outside diameter 13.3mm. Use with FS015 hose clips.

Always route hose carefully to avoid kinks and maximise the bend radius where possible. Work backwards from cylinders to reservoirs, then cut to fit once hoses are clipped in place with sufficient play. Don't cut new hose to length from your existing hoses as some original hoses are unnecessarily short.

Quantity price is per 30cm (per foot), but supplied as a continuous length, i.e. if you order quantity 5 you will receive one 150cm length (5 x 30cm). Required quantities are as follows:

FIAT X1/9 right hand drive cars (e.g. UK & Australia) -

• Brake circuit (total) for 1300 Lido and all 1500 models, 10 x 30cm lengths;

FIAT X1/9 left hand drive cars (e.g. USA & mainland Europe) -

• Brake circuit (total) for 1500 models, 10 x 30cm lengths;

Lancia Montecarlo S1 cars (both left and right hand drive) with brake reservoir on the passenger side -

• Brake circuit (total) for late cars, 10 x 30cm lengths;

Lancia Montecarlo S2 cars (both left and right hand drive) with brake reservoir on the driver side -

• Brake circuit (total), 5 x 30cm lengths;

Important: The hose size must match your master cylinder fittings and reservoir outlets. Always confirm your existing setup prior to ordering as differing parts may have been previously used. For clutch and 6mm brake circuits, see reservoir hose BR031.