
Full gasket set for 1500 engines produced to 1982 with ten M12 studs/bolts (19mm hex heads). Complete with valve stem oil seals and all four shaft seals.
Supplied by Guarnitauto, the leading engine gasket manufacturer.
Set contains:
- Aux shaft lock plate gasket
- Aux shaft oil seal
- Cam base gasket (0.2mm thick)
- Cam cover gasket
- Cam housing end plate gasket
- Cam shaft oil seal
- Crank cover gasket - Front
- Crank cover gasket - Rear
- Crank shaft oil seal - Front
- Crank shaft oil seal - Rear
- Cyclonic trap base gasket
- Distributor shaft base gasket
- Fuel pump spacer inner gasket (three supplied, 0.4mm, 0.8mm & 1.0mm thick)
- Fuel pump spacer outer gasket
- Head gasket M12 (uncompressed thickness ~1.4mm)
- Manifold 2 piece gasket (carburettor use only)
- Oil filler cap seal
- Oil pump gasket
- Sump gasket (either rubber or cork composite)
- Thermostat cover gasket
- Thermostat housing to head gasket (two supplied, standard & EGR blanking)
- Thermostat O-ring seal
- Valve stem oil seals (8)
- Water cover gasket - Front (1500)
- Water cover gasket - Rear (1500)
- Water pump by-pass pipe gasket
- Water pump housing to engine gasket
For
carburettor engines, the
Carburettor base gasket
and
Exhaust flange gasket
are
not included, but can be ordered separately.
For
Fuel Injection engines, you will need to supplement the set with the
Fuel Injection manifold gasket
and
Fuel Injection intake gaskets
if required.
Note:
The
Water pump gasket for cars without air-conditioning is also available.