X1/9 Swing Arm Ball-Joint N/S

£154.80 (£129.00 ex VAT)

Ball joint for the near-side (left) rear suspension swing arm (lower wishbone). Supplied with class 10.9 high tensile bolts & nuts to replace the existing rivets. We additionally include industry approved Nord-Lock washers for increased reliability of the through fittings and the correct tall type nyloc nut for the ball-joint end. Shipped with our own replacement ball-joint fitting guide.

Note: The complete swing arm will need to be removed to replace the ball joint, so you may also require:
  • Hub Nut - CV flange shaft must be taken out of hub as it prevents ball joint removal.
  • 1300 or 1500 Wheel Bearing V-seal - The inner seal is located on the CV flange shaft that needs to be removed.
  • M14 x 1.5 Nyloc Nut, Tall Type - two required for swing arm mountings and one for track adjusting rod to swing arm.
  • M10 x 1.25 Nyloc Nut, Tall Type - two required for strut to hub carrier.

Also applicable to Lancia Beta Scorpion and Montecarlo S1 & S2.

Add to Cart:

  • Code: SS051
  • In Stock


Your IP Address is: 44.192.70.216
Copyright © 2021 Eurosport (UK)